| Preamps |
|
| Home | Products | About Us | Testimonials | Sound Samples | Featured Artists | |
|
|
All Pick-up the World pre-amps use our own discreet transistor circuitry and are designed to be absolutely transparent and noise free. The input impedance is 10 Megohms, with variable gain from 0 to 40db. These pre-amps use the highest quality components and are point to point wired for the straightest signal paths possible. |
|
|
|
|
Retail $150.00, Buy Direct $125.00 |
|
This
is our top of the line pre-amp. The same size as the Power Plug,
this box has two inputs with individual gain and volume controls
for each and the signals can be routed in either true stereo or
mono modes to the output. There is also a convenient On/Mute/Off
switch on the side of the box that is handy for taking breaks or
switching instruments on the fly. Whether in stereo or mono modes,
the output is designed to integrate into virtually any input. All
other features are the same as the Power Plug and the battery life
is 400 hours.
|
|
This
is a very popular pre-amp in a belt clip configuration. It has ¼"
input and output jacks, and is small enough that it can also be
mounted on some instruments directly with Velcro tape, wire ties,
or other hardware. It has all the same features as the Power Plug,
and is ideal for smaller instruments such as Violins, Mandolins,
Banjos and other instruments where a Power Plug would be too large
to plug into the instrument. |
|
This
is a stereo version of our popular Line Driver. Two signal channels
enter the box through a ¼" TRS stereo jack, and the
outputs are separate mono ¼" jacks. Each input has a
separate gain trim control and volume and the output can be selected
to be blended mono out the tip output jack, or true stereo through
the tip and ring jacks. This pre-amp is recommended for all our
stereo piano, harp and hammered dulcimer kits. Available in either
9 or 18 volt versions. Box size is 3 1/8" x 2 1/8" x 1
1/8" |
|
This
is a very crafty and highly popular design. The entire pre-amp circuit
is housed in a small enclosure that mounts to the underside of the
soundboard next to the soundhole. A small black ½" diameter
thumbwheel protrudes into the soundhole opening by 1/8", making
this a truly 'stealthy' pre-amp. A high quality battery holder is
included, and it comes pre-wired to an endpin jack with a battery
switch in it. The Stealth pre-amp input is a mono 1/8" mini
plug, and can be used with virtually all pickups on the market (except
B-band and Schertler Bluestick). The gain is fixed at 15db, and
the battery life is 800 hours. Available in either 9 or 18 volt
versions. |
|
Stereo Stealth
Pre-amp This
is a stereo version of the Stealth pre-amp, and has two thumbwheel
volume controls. The output is either true stereo or blended to
mono by the flick of a micro switch. Each channel has the same features
as the mono Stealth pre-amp and the inputs come in through a common
mini 1/8" TRS stereo jack. Accepts all pickups except B-band
and Schertler Bluestick. Available in either 9 or 18 volt versions. |
|
PUTW
End Pin Preamp: 9V - Retail
$100.00, Buy
Direct $90.00 |
|
PUTW
P5 Solid body pre-amp kit: This
is a small, unpackaged version of our low noise pre-amp that is
designed to be installed into solid bodied instruments. A gain trim
control adjusts from 0-40 db of gain, and these are suitable for
all type of pickups. Two of these are used when blending film pickups
with magnetic signals on board, or the two signals can be routed
out of the instrument through a stereo jack. All hardware is included
for 9 volt opperation. Can accept power supplies from 9-48 volts. |
|
| Home | Products | About Us | Testimonials | Sound Samples | Featured Artists | |